Meridian G68 Uživatelský manuál stáhnout pdf

C3 Custom Code Crafters (Europe) Ltd.

One, The Market Place, Station Road, Thorpe-Le-Soken, Essex, CO16 0HQ.

Telephone: +44 (0) 1255 862850 Fax: +44 (0) 1255 863909 Internet: http://www.C3-eu.com

Meridian G68

GENERAL INFORMATION

SIMPLWINDOWS FILE NAME:

C3 Meridian G68 processor V1.02.umc

CATEGORY:

Receiver / Processor

CURRENT VERSION:

1.02

PROGRAMMER: GO

SUMMARY:

Full control of main zone, copy zone & dsp with full feedback

SYSTEMBUILDER COMPATIBLE Yes

GENERAL NOTES:

This module will control all functions on a Meridian G68 processor. It has been designed in such a

way as to extract as much feedback information as it can from the processor.

Functions that can be controlled from this module include:

• Main source selection by way of analog input

• Main volume & mute control

• Main source dsp fuctions by way of analog input

• Zone source selection by way of analog input

• Zone volume & mute control*

• OSD, setup & menu functions

*Note: There is no “un-mute” command for the G68 zone output. However this module gets

round this and provide standard mute / un-mute & toggle functions in a similar manner to the

main zone. This also means that muting the copy zone does not kill the copy zone source

feedback as is the case on other modules for controlling this device. There is an option on the

module to determine how the copy mute function operates. This is discussed later in this

document.

All C3 modules use analogs for source selection. This module uses the following values to set the

sources and dsp functions:

Sources:

Source Main Copy Notes

CD 1d 1d

Tuner 2d 2d

Aux 3d 3d

DVD 4d 4d

Cable 5d 5d

TV 6d 6d

Satellite 7d 7d

VCR1 8d 8d

VCR2 9d 9d

Tape 10d 10d

Game 11d 11d

Disc 12d 12d

Main Source NA 13d Will cause copy to follow main

Copy mute NA 14d Not required if using the built-in mute functions

Off 65535d 65535d Default ‘power off value’ parameter

Assigning any valid source to an input will switch on the main or copy zone circuits automatically.

Once powered up the main or copy zone will adjust the volume as set by the ‘default volume’

parameter. Any analog source can be forced off by setting the value = ‘power off value’

parameter. The default is 65535d.

Using analog source values enables all C3 audio/video modules to be dropped into existing

programs where a PAD8 or BiPad may be used. This allows for greater programming flexibility.

The dsp functions will be covered on the next page

1 2 3 4 5

Meridian G68 1